Flat Roofing
Flat Roofing Specialists for Extensions, Dormers and Garages
Single-ply, GRP and high-performance felt systems with proper falls and detailing.
Overview
Flat roofs fail at the details, not in the middle. Ponding water, poorly formed upstands and cheap trims cause the overwhelming majority of problems we're called to. We design falls, terminations and outlets first, then install a system rated for the exposure and traffic the roof actually gets.
Common warning signs
- Standing water more than 48 hours after rainfall
- Blistering, splitting or crazing in the membrane
- Lifting or cracked edge trims
- Damp appearing at the junction with the main wall
- Sagging or spongy areas underfoot
- Old three-layer felt beyond 15–20 years of service
Our process
- 01
Tell us about the issue
Send photos, symptoms and access details through the enquiry form or the demo assistant.
- 02
Initial phone assessment
A roofer talks the problem through, flags urgency and books the right survey slot.
- 03
Roof inspection
On-site or drone survey with photographs of every defect we find.
- 04
Written quotation
Itemised, fixed-scope quotation with materials, access and guarantee terms in writing.
- 05
Work completed
Scheduled works with photo updates each day and a clean-site policy throughout.
- 06
Sign-off and aftercare
Final walk-round, handover pack, guarantee documents and aftercare reminders.
Materials we use
- EPDM rubber single-ply membranes
- GRP fibreglass systems
- Reinforced bituminous membranes
- Warm-deck PIR insulation build-ups
- Powder-coated aluminium edge trims
Flat Roofing FAQs
Relevant projects
Demo case studies for this service
Ready for a straight answer on your roof?
Get an indicative estimate in under a minute, or book an inspection and we'll put a written quotation in your hands.